Page 4/9
S
afety data sheet
according to 1907/2006/EC, Article 31
Printing date 26.06.2014
Revision: 26.06.2014
Version number 1
Trade name:
Hilti HIT-RE 500
(Contd.
of page 3)
3814
7
Handling and storage
·
Handling
·
Precautions for safe handling
The usual precautionary measures should be adhered to general rules for handling chemicals.
Take note of emission threshold.
Use only
in well ventilated areas.
Check the expiry date: see imprint on manifold (month/y
ear).
Do not use expired mortar!
·
Information about protection against explosions and fires:
Keep ignition sources away
- Do not smoke.
·
Conditions for safe storage, including any incompatibilities
·
Storage
·
Requirements to be met by storerooms and containers:
Keep in a cool, dry and dark place; 5 °C to 25 °C.
·
Information about storage in one common storage facility:
Store away
from foodstuffs.
·
Further information about storage conditions:
Protect from heat and direct sunlight.
·
Storage class
As per VCI (1991) storage classification concept.
8 A
·
Specific end use(s)
Adhesive mortar for rebar and anchor fastenings in solid concrete
8
Exposure controls/personal protection
·
Control parameters
·
Components with limit values that require monitoring at the workplace:
The product has a pasty consistency.
Exposure limit values for respirable dusts ar not relevant for this product.
·
Additional information:
The lists that were valid during the compilation were used as basis.
·
Exposure controls
·
Personal protective equipment
·
General protective and hygienic measures
The usual precautionary measures should be adhered to general rules for handling chemicals.
Take off immediately
all contaminated clothing
Wash hands during breaks and at the end of the work.
Store protective clothing separately.
Avoid contact with the eyes and skin.
Do not eat, drink or smoke while working.
Use skin protection cream for preventive skin protection.
Clean skin thoroughly immediately after handling the product.
Ensure that washing facilities are available in the work place.
Do not carry cleaning cloths impregnated with the product in trouser pockets.
Keep away from foodstuffs, beverages and food.
·
Breathing equipment:
Not necessary
if room is well-ventilated.
In case of brief exposure or low pollution use breathing filter apparatus.
In case of intensive or longer exposure use
breathing apparatus that is independent of circulating air.
·
Recommended filter device for short term use:
Filter AX
·
Protection of hands:
Protective gloves
Only use chemical-protective gloves with CE-labelling of category III.
EN 374
Avoid direct contact with the chemical/ the product/ the preparation by organizational measures.
The glove material has to be impermeable and resistant to the product/ the substance/ the preparation.
·
Material of gloves
Nitrile rubber, NBR
Recommended thickness of the material:
³
0,4 mm
The selection of the suitable gloves does not only depend on the material, but also on further marks of quality and varies
from manufacturer to manufacturer.
As the product is a preparation of several substances, the resistance of the glove
material can not be calculated in advance and has therefore to be checked prior to the application.
·
Penetration time of glove material
The exact break trough time has to be found out by the manufacturer of the protective gloves and has to be observed.
·
As protection from splashes gloves made of the following materials are suitable:
Nitrile rubber, NBR
(Contd.
on page 5)
ES EN
